tel : +86-18059296519
Whatsapp : +8618059296519
E-mail : [email protected]
Pipe Elbows are installed between two lengths of pipe or tubing to allow a change of direction, usually at a 90°or 45°angle.
Misurare :
1/2''-48''Standard :
ASME B16.9, MSS SP-43, DIN 2605/JIS B2313, B/T12459, GB/T13401, SH3408/SH3409, HG/T21635, HG/T21631.Materiale :
Nickel Alloy, Duplex Steel, Stainless SteelDescription
Steel pipe elbow (sometimes also refereed as bends) is a key part in a pressure piping system used to change the fluid flow direction. It is used to connect two pipes with same or different nominal diameters, and to make the pipe and thus the fluid direction turn to a certain direction of 45 degree or 90 degree.
Classification of Steel Pipe Elbows
Steel pipe elbows can be classified through following various parameters:
According to fluid flow direction of the pipes, elbows can be divided into different degrees, such as 45 degree, 90 degree, 180 degree, which are most common elbows. Also there are 60 degree and 120 degree elbows for some special pipelines. This degree is just an representation of the angle by which the fluid flow is going to change after flowing through the said elbow.
| Type: | SR,LR |
| Size: | 1/2''-48'' |
| WT: | SCH5S-SCHXXS |
| Radius: | 1.0D, 1.5D, etc. |
| Material: | Nickel Alloy, Duplex Steel, Stainless Steel |
| Standards: | ASME B16.9, MSS SP-43, DIN 2605/JIS B2313, B/T12459, GB/T13401, SH3408/SH3409, HG/T21635, HG/T21631 |
I gomiti dei tubi vengono installati tra due tratti di tubo o tubazione per consentire un cambio di direzione, solitamente con un angolo di 90° o 45°.
I gomiti dei tubi vengono installati tra due tratti di tubo o tubazione per consentire un cambio di direzione, solitamente con un angolo di 90° o 45°.
I gomiti dei tubi vengono installati tra due tratti di tubo o tubazione per consentire un cambio di direzione, solitamente con un angolo di 90° o 45°.
I gomiti dei tubi vengono installati tra due tratti di tubo o tubazione per consentire un cambio di direzione, solitamente con un angolo di 90° o 45°.
I gomiti dei tubi vengono installati tra due tratti di tubo o tubazione per consentire un cambio di direzione, solitamente con un angolo di 90° o 45°.
Pipe Elbows are installed between two lengths of pipe or tubing to allow a change of direction, usually at a 90°or 45°angle.
Pipe Elbows are installed between two lengths of pipe or tubing to allow a change of direction, usually at a 90°or 45°angle.
Pipe Elbows are installed between two lengths of pipe or tubing to allow a change of direction, usually at a 90°or 45°angle.
No.1633, Binhai Road, Wenzhou Economic Development Zone, Wenzhou, China
Rete IPv6 supportata
